Filter
Top Products
EVERFOCUS ELECTRONICS CORPORATION
Control Setting Menu
Diagram 15
Diagram fifteen is a screen shot of the Control Setting Menu. This menu is for setting
up a connection from the digital recorder to a computer to transfer instructions or
information using the HyperTerminal program in Windows. In the Control Setting
Menu the following fields are defined as follows:
RS232:
¾ RS232 Baud Rate: This field is to set the speed at which is used to transmit
instruction or information through the RS232 port on the DVR. There are
six different speeds, 1200 BPS, 2400 BPS, 4800 BPS, 9600 BPS, 19200 BPS,
and 3840 BPS. The default setting from the factory is 9600 BPS. To change
this, simply use the Jog Dial on the DVR. Press the Enter key to make your
selection.
¾ RS232 Stop Bit: This field is to set the stop bit for the RS232 connection.
There are two different stop bits, 1 or 2. The default in the DVR is set to 1.
To change this, simply use the Jog Dial on the DVR. Press the Enter key to
make your selection.
30