Enviro ENVIRO Indoor Fireplace User Manual


 
33
Figure 54. Charcoal Pieces & Ember Installation.
Secondary Installation
9. Remove knob and nut from the fan controller. Place the knob stud through the fan hole in the control
panel, the controller tab should align with the control panel hole (see Figure 49). Tighten the nut on
the front side to keep the fan controller in place (see Figure 50), then install the knob onto the stud.
10. Use marrettes or approved connectors to connect the fan wiring harness wires to the house wiring
when the Retreat is installed.
11. Re-install the control panel wiring and the control panel.
LOG SET AND EMBER INSTALLATION:
NOTE: The charcoal pieces and logs are fragile and should be handled gently.
The placement of the charcoal pieces, embers, and logs are not arbitrary. If they are positioned incorrectly,
the ames can be “pinched” and will not burn correctly. The burner comes with six (6) locator pins
(pointed out in Figure 54) which make alignment easier. The locator pins are long enough to go through
the charcoal and be used to locate the logs. Carefully set the three (3) charcoal pieces in place.
After the charcoal pieces are in, spread the
rockwool embers apart, and place them (see
Figure 49) onto the burner in a sparse but even
manner to create a realistic look.
WARNING: DO NOT pack this ember material
as this could create an unsafe condition. The
ember material should be lightly placed so it
doesn’t densely block any of the burner ports.
DO NOT place any of the embers against the pilot
assembly.
Caution: Use only the type of ember material
supplied with this replace. Due to the irregular
size of the ember material, there will be more
than required. Use of other foreign materials on
the burners may create dangerous conditions.
Figure 55. Left & Right Logs Installation.
Figure 56. Centre Log Installation.
Each log sits on
two (2) locator
pins and should
lean against
the liner walls
(see Figures 55
& 56).