Enviro ENVIRO Indoor Fireplace User Manual


 
10
Maintenance And Service
CLEANING DECORATIVE SURFACES:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the
nish, including cleaners, polish and nger prints. It is important to note that ngerprints and other
marks can leave a permanent stain on plated nishes. To avoid this, give the face a quick wipe with
denatured alcohol on a soft cloth BEFORE lighting the replace. Never clean the face when it is
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into
the surface.
GLASS DOOR REMOVAL:
In order to install the log set, and for
regular cleaning, the glass door must be
removed. There are two (2) door latch
mechanisms under and two (2) above
the glass door shown in Figure 6 & 7.
Each latch has two (2) nger grooves,
use these to pull the mechanisms straight
out. When the latches are unhooked, lift
the door up and forward off the unit.
To replace the glass door, simply reverse
the above procedure.
Warning: Do not touch or attempt to
remove the glass if the replace is not
completely cold.
WARNING: Never operate the
replace with the glass removed.
Figure 6. Bottom latches for glass door, disengaged.