Filter
Top Products
Initial Installation
QUALIFIED INSTALLERS ONLY
INTRODUCTION:
This section of the owner’s manual is for the use of qualied technicians only. Fireplace placement,
hearths, facing, mantles, and venting terminations will be covered, as well as the gas and electric
systems. There are several installation safety guidelines that must be adhered to. Please carefully read
the safety precautions at the front of this manual.
Warning: Clearances must be sufcient to allow access for maintenance and service.
VENT HEAT SHIELD SET-UP:
The vent shield must be set-up prior to the Retreat
being installed.
1. The heat shield is shipped at (see Figure 14).
The at shield must be bent up 90° to the top of
the unit (see Figure 15).
2. Bend the two (2) side aps 45° back around the
vent (see Figure 16).
Figure 14. Vent Heat Shield Flat.
Figure 15. Vent Heat Shield Bent Up.
Figure 16. Vent Heat Shield Sides Bent.
13