Filter
Top Products
AREAS FOR ROUTINE INSPECTION
The following should be inspected periodically to ensure that the appliance is operating at its optimum and giving
you excellent heat value:
2 3 DAYS/WEEKLY SEASON or 2 TONS OF FUEL
Burn Pot and Liner Exhaust Vent
Ash Pan Fresh air Intake Tube
Inside Firebox Blower Mechanisms
Behind Firebox Liners Heat exchanger tubes
Burn Pot and Liner Latch Mechanism of ash pan
Door Glass Door Latch
Heat exchanger tubes All Hinges
Ash pan and Door gaskets Post Season Clean-up
TOOLS REQUIRED TO CLEAN UNIT:..Torx T-20 Screwdriver, Brush, Soft Cloth, Vacuum with fine filter bag
ASH PAN AND DOOR GASKETS
After excessive use the gasketing may come loose. To repair this, glue the gasketing on using high-temperature
fiberglass gasket glue available from your local dealer. This is important to maintain an airtight assembly. DO
NOT PLACE UNBURNED OR RAW PELLET FUEL IN ASH PAN.
BURNER POT AND LINER
This is the ‘pot’ where the pellets are burned. Every two to three days (when the unit is cold), remove the burn-
pot liner from the stove. Using a metal scrapper remove material that has accumulated or is clogging the liner’s
holes. Then dispose of the scrapped ashes from the liner and from inside the burn-pot. Place the burn-pot back
into the stove, making sure that the pipes are properly inserted into the burn pot and the front tabs are in place in
the firebox. Place the liner back into the burn-pot, making sure that the ignitor hole in the liner is aligned with the
ignitor tube. Pushing the liner up against the igniter tube.
To remove the burn pot and burn pot liner open the door using the door handle provided located on the left-hand
side of the stove, swing the door open. Lift the liner from the burn pot, lift the burn pot from the firebox by gently
lifting the front of the burn pot up first then sliding the assembly from the air intake tube and the igniter cartridge.
IGNITER TUBE
FRESH AIR
TUBE
BURN POT
BURN POT
LINER
INSERT ASH REMOVAL:
The EF 4 pellet stove insert does not have an ash pan and the ashes must be vacuumed out of the firebox on a
daily basis. CAUTION: BECAUSE THE FLY ASH IS VERY FINE, THE USE OF A VACUUM BAG WILL BE
REQUIRED TO PREVENT ASH FROM BEING BLOWN BACK INTO THE ROOM. Please pay special
attention that there are no hot ashes in the firebox or there could be a possibility of a fire hazard inside
the vacuum cleaner. Place all hot ashes into a noncombustible container.
FREESTANDING ASH PAN
: ( # 1 SEE PAGE 10)
This part is located under the burner, in the pedestal and has a latching mechanism to secure it. To remove the
ash pan, unlock the latch on the pedestal cover and then pull the pan out. Dump the ashes into a metal container
stored away from combustibles. Monitor the ash level every week. Remember that different pellet fuels will
8