Filter
Top Products
ASSEMBLING THE FACE PLATE FOR THE FPI MODEL
1. To assemble the surround panels, lay the panels face down on a soft flat surface and align the outer
edges of the sides with the top panel. Bolt the sides to the top using the hardware provided. (4 x 1/4” nuts
and bolts)
2. Assemble the brass frame using the corner hardware and screws supplied in the face plate packaging.
Install corner hardware into the side brass, then push into the top frame.
3. Place the brass frame over the panel assembly.
4. Place the assembled surround panel around the stove, align the slots with the screw heads. Push back
and then down to engage the surround slots on the mounting screws. Make sure the top surround panel
sits flat on the stove
MAGNETIC STRIPS
CORNER HARDWARE
Sizing of face plates for FPI:
STANDARD: 40” X 27 7/8”
FPI PEDESTAL INSTALLATION
The pedestal for the EF 4 insert (FPI) is packaged in the hopper of the appliance. Secure the Z style
bracket onto the back two pedestal mounting screws with the inserted nuts facing up. Insert leveling
legs into the nuts on the Z bracket if necessary.
Place the front portion of the pedestal into the front pedestal screws, there are two slots in the pedestal
that fit over these screws. Finish securing the pedestal using the (4) four T-20 Torx screws provided.
This will cover and seal the ash pan hole in the bottom of the firebox inside the appliance.
INSERT T-20
TORX SCREWS
HERE
INSERT PEDESTAL
SCREWS HERE
LEVELING LEGS
PEDESTAL REAR PEDESTAL FRONT
16