Filter
Top Products
HOW TO START AND OPERATE YOUR PELLET APPLIANCE
Dial-A-Fire
Heat Output
Knob
Knob B
Start-up
Switch
Auger Light
Convection
Blower Speed
Control
KNOB A
1. Check and fill hopper with pellets.
2. Make sure unit is plugged into a
working outlet.
3. Switch the power “ON” by pushing the
start up switch once only.
4. Turn knob “B” to the 12 o’clock
position. (Lower grade pellets may
need a higher setting on the feed
rate). NOTE: unit will take longer to
light if the hopper has been completely
emptied.
5. Wait until the fire is established, then
turn knob “B” to the desired heat
output. (The stove may not be able to
burn in the BLUE ZONE if poor quality
wood pellets are being used. Adjust the
Slider Damper to the appropriate
setting (SEE PAGE 8).
6. If the stove should shut off after 15 minutes and there is still a fire in the firebox – press the start
up switch once more. If the fire went out, return to step number 2 and re-light the stove.
KNOB “A”:
Fan Controller. By adjusting the knob you will vary the rate of airflow into the room by
varying the speed of the convection blower. When you first start the stove it should be placed in the
“OFF” position in order to heat the unit as quickly as possible. Once the room has come up to
temperature the control may be set to a comfortable level. *Note: The convection blower may cycle to
high automatically depending on the setting of knobs “A” and “B”. This is a normal safety feature of the
unit.
The flashing green “Auger Light”
corresponds to the timing of the auger turning .
KNOB “B”:
Dial a Fire Heat Output Knob. This knob controls the amount of heat output. The dial has a
scale with the blue zone representing the coolest setting of the stove, and the red zone representing
the hottest setting. The scale on knob “B” represents a range, not exact at times or fuel quantities.
Wood pellets of differing quality may effect the performance of the stove. If the stove has trouble
operating at either end of its range, turn the heat output knob back slightly.
TURNING YOUR PELLET STOVE OFF
To turn your stove off, simply turn the HEAT OUTPUT knob (knob “B”) counter-clockwise until the knob
clicks to the “OFF” position. This will stop the feed of pellets. The blowers will continue to run and cool
the stove. When cool enough, the stove will shut down.
6