Filter
Top Products
MASONRY FIREPLACE INSERT INSTALLATION, MODEL FPI
The Fireplace Insert model includes surround face. (Surround assembly instructions are in this manual).
(SEE PAGE 15 in this manual)
CLEARANCE TO COMBUSTIBLES:
Side wall..................................................9” (200 mm) from the body of the heater
Facing on masonry fireplace...................9” (200 mm) from the body of the heater
Mantle......................................................8” (200 mm) from the body of the heater
FIREPLACE INSERT SIZE:
Width.......................................................22” (550 mm)
Height......................................................21 1/8”” (537 mm)
Depth.......................................................20 9/16”” (522 mm)
- A non-combustible hearth pad must cover
combustible flooring underneath, as well as 6”
(150 mm) in front of the heater and 6” (150 mm)
to the side of the heater.
1. Install the hearth pad
2. Lock fireplace damper in the open position
3. Install positive flue connector at the fireplace
dampers
4. Connect a Tee or a 90 degree elbow to the
exhaust pipe
5. Install flexible stainless steel liner or listed pellet
vent to the top of the chimney
6. Install fresh air intake either through the back of
the fireplace or through the positive flue
connector. (This is optional) However this is
recommended.
When installing the fireplace insert into a zero clearance
fireplace, DO NOT cut or modify any factory firebox parts.
If the fireplace insert does not fit into a zero clearance
fireplace we recommend you use ENVIROFIRE model FS
and install it as a hearth mount unit.
* NOTE: DO NOT remove the damper from the fireplace.
Install a 3” (76 mm) stainless steel exhaust flex pipe from
the stove to the top of the chimney
15