Filter
Top Products
30
Secondary Installation
BURNER AND FAN REMOVAL:
1. Remove brick liners, see steps 1 to 4 in SECONDARY INSTALLATION - CERAMIC BRICK LINER REMOVAL.
2. The control panel is held in place with a T-20 screw on each end of the panel. Remove the two (2)
screws and the control panel.
3. Undo the six (6) screws holding the burner down, the andirons and grate can be removed from the
burner or left on. Pull the burner to the left approximately 1” (25 mm), this is done in order to slide
the venturi out of the venturi box. Remove the burner from the rebox.
4. Four (4) screws along the top of the air deector hold it in place, remove the screws and the
deector.
5. Remove the ten (10) screws around the perimeter that hold the valve tray in place and remove the
valve tray.
6. On either side of the fan there is a screw fastening the fan mount to the rebox, remove the screws
to remove the fan.
Re-install everything by following steps 1 to 6 in reverse order.
Control Panel
Andirons and Grate
Burner
Air Deflector
Valve Tray
Fan
Figure 43: Removal of DV50DX Burner and Fan.