Filter
Top Products
Maintenance And Service
CLEANING DECORATIVE SURFACES:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the
nish, including cleaners, polish and nger prints. It is important to note that ngerprints and other
marks can leave a permanent stain on plated nishes. To avoid this, give the face a quick wipe with
denatured alcohol on a soft cloth BEFORE lighting the replace. Never clean the face when it is
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into
the surface.
If your ngers come into contact with the antique copper nish, the oils left as ngerprints on the copper
can cause discoloration, which will eventually turn green in that area. You can clean the patina or discolored
areas of the antique copper nish with “OO” 3M green sanding pads. These can be purchased from most
hardware stores. On the areas with discoloration, use the sanding pads to sand in the same direction as
the brushed nish, then blend the nish by feathering in the surrounding area. This renishing procedure
has been approved by the manufacturer and will not harm the nish. Please note: ANTIQUE COPPER IS
THE ONLY FINISH THAT CAN BE SANDED, DO NOT SAND PEWTER, GOLD OR NICKEL FINISHES.
GLASS DOOR REMOVAL:
glass
In order to install the log set, and for regular
cleaning, the glass door will need to be
removed. With the face off, there are two
(2) handles on either side of the glass. They
rotate 90° until parallel with the oor (see
Figure 8). The top of the glass will move
away from the rebox and then the glass
door can be lifted off the resting points.
To replace the glass door, simply reverse the
above procedure.
Warning: Do not touch or attempt to
remove the glass if the replace is not
completely cold.
WARNING: Never operate the replace
with the glass removed.
Figure 8. Glass Removal Handle
10