Filter
Top Products
LOG SET AND EMBER INSTALLATION:
The placement of the logs is not arbitrary. If they are positioned incorrectly, the ames can be “pinched”
and will not burn correctly. The burner (Figure 34) and a few of the logs come with locator pins, notches,
and ledges which make alignment easier. The andirons and grate must be installed for the logs to be
placed properly. Using the pictures provided, carefully set the logs in place (see Figures 35 through 41).
NOTE: The logs are fragile and should be handled gently.
Maintenance: Once a year the logs should be removed and checked for deterioration or large amounts
Pins
Ledges
Figure 34. Placement of ledges and pegs in empty
rebox.
26
Secondary Installation
CERAMIC BRICK LINER REMOVAL:
WARNING: DO NOT INSTALL LINER IF UNIT IS HOT.
1. Remove glass door (see MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL)
2. Carefully remove the log set if it was installed.
3. Remove both side brick liners by sliding them out the front. Be careful not to scrape the liners on the
bafe tabs at the top.
4. Hold the back of the top liner up while lifting the back liner off the air deector ledge then out. Slide
the top liner out from the lip on the bafe then remove it from the unit.
of soot. A small amount on the bottom side of the
logs is normal. Remove and replace the logs in the
same manner described in this section.
If new/more embers and rock wool is required,
contact your nearest ENVIRO dealer.
Never operate the replace with the glass
door removed.
Figure 34: This is how the re box looks with only
the andirons and grate in place. This points out the
three ledges at the back and three locator pins on
the burner.
Right Side Brick Liner
Leftt Side
Brick Liner
Top Brick Liner
Back Brick Liner
Air Deflector Ledge
Baffle Lip
Baffle Tab
For clarity unit is not shown.
5. If the bafe needs to be removed use a T-20
screwdriver to loosen off but not remove the
two (2) screws at the back of the bafe and
remove the two (2) screws at the front of the
bafe. Slide the bafe up over the back screws
then out.
To install the liners follow steps 1 to 5 in reverse.
Important installation notes:
Ensuring the side brick liners are behind the bafe
tabs and are ush against the rebox walls.
When sliding the bafe into place making sure
to hook the back into place on the two loosened
screws.
To install the log set follow the instruction in LOG
SET AND EMBER INSTALLATION.
Figure 33: Cast Iron Brick Liner Installation.