Filter
Top Products
26
Installation
ASSEMBLY AND INSTALLATION OF INSERT SURROUND PANELS:
To assemble the surround panels, lay the panels face down on a soft
flat surface and align the outer edges of the sides with the top panel.
Using four T20 screws up through the side panels into the top (see
top left figure).
INSTALLATION AND REMOVAL OF CONTROL PANEL IN THE SURROUND PANEL:
When installing the circuit board control panel into the surround panel, the surround does not need to be assembled
The circuit board will be found in the firebox.
Place the circuit board control panel on the backside of the right
surround panel so the hinge is on the outside and the top and
bottom holes on the control panel line up with those on the
surround. Attach using two T20 screws through the front of the
surround into the circuit board control panel.
After the surround has been assembled and is ready to be installed
on the the unit plug the wiring harness into the control panel (see
top left figure).
REMOVAL:
When maintenance is required on the unit the surround must be
removed. Pull the surround straight up till it stops then pull it out
about 4” (10cm) and rest the surround on top of the unit while the
control panel is removed or disconnected.
If electrical connection is required for the maintenance remove
the circuit board control panel from the surround.
If electrical connection is not required for the maintenance remove
the wiring harness from the bottom of the circuit board control.
Place the assembled surround panel around the
stove; align the slots with the screw heads. Push
surround in then down to engage the surround
slots on the mounting screws (see right). Make
sure the top surround panel sits flat behind the
stove top.