Filter
Top Products
10
2-3 DAYS/WEEKLY SEASON or 2 TONS OF FUEL
Burn Pot and Liner Exhaust Vent
Ash Pan Fresh air Intake Tube
Inside Firebox Blower Mechanisms
Door Glass Heat exchanger tubes
Heat exchanger tubes Behind firebox liners
Ash pan and Door gaskets All Hinges
Door Latch Post Season Clean-up
TOOLS REQUIRED TO CLEAN UNIT
Torx T20 Screwdriver,
5
/16” Wrench or Socket, Brush, Soft Cloth,
Vacuum with fine filter bag
BURN POT AND LINER (2-3 days)
This is the ‘pot’ where the pellets are burned. The Burn Pot and
Liner should be inspected every two to three days, to ensure proper
air flow through the liner. Failure to keep the liner clean may
cause a build up of fuel past the burn pot liner and up the
drop tube. This will cause the auger to jam and may result
in pellets burning in the drop tube and hopper. Open the
Routine Cleaning and Maintenance
Burn Pot
Liner
Igniter
Air
Intake
Tube
Burn
Pot
door using the door handle provided located on the right-hand side of the stove, swing the door open. Remove
the burn-pot liner from the stove. Using a metal scrapper remove material that has accumulated or is clogging the
liner’s holes. Then dispose of the scrapped ashes from the liner and from inside the burn-pot. Place the burn-pot
back into the stove, making sure that the pipes are properly inserted into the burn pot. Place the liner back into the
burn-pot, making sure that the ignitor hole in the liner is aligned with the ignitor tube. Pushing the liner up against
the ignitor tube.
● If after long periods of burning the fire continually builds up and overflows the burn pot or there is a build
up of clinkers, this is an indication that the pellet fuel quality is poor or the stove may need cleaning. Check
the stove for ash build up (clean if required) and adjust the Slider / Damper to produce the proper clean
combustion.
ASH PAN AND DOOR GASKETS (weekly)
After excessive use the gasket may come loose. To repair this, glue the gasket on using high-temperature fiberglass
gasket glue available from your local ENVIRO dealer. This is important to maintain an airtight assembly.
ASH PAN (weekly)
The ash pan is located under the burner. Dump the ashes into a metal container stored away from combustibles.
Monitor the ash level every week. Remember that different pellet fuels will have different ash contents. Ash
content is a good indication of fuel efficiency and quality. Refer to “Warnings and Recommendations” for disposal
of ashes.
DO NOT PLACE UNBURNED OR RAW PELLET FUEL IN ASH PAN.
Freestanding:
To remove the ash pan, simply turn the knob and pull out towards the front.
Insert:
To remove the ash pan open the door, remove the burn pot, then pull the ash pan out.
The following list of components should be inspected and maintained routinely to ensure that the appliance is
operating at its optimum and giving you excellent heat value: