Filter
Top Products
Installation
DOOR INSTALLATION:
Please inspect all components for damage. If damage has occurred, please contact the courier company,
dealer, or distributor and have components repaired or replaced before installation. Remove the door
from the packaging. Inspect the door assembly for damage.
1. Install door handle as shown in Figure 36.
Close the door
assembly and turn
the door handle
downwards until
door is tight.
Thread slider damper
handle onto slider
damper control on the
side of the unit.
Nut
Cast Latch
Washer (x2)
Spring Washer
Furel
Handle
4. Please clean all ngerprints
off of all plated surfaces,
with denatured alcohol
on a soft cloth, before
ring the unit each time.
Fingerprints, etc., can
become permanently
etched into the plating
if not removed before
operating the stove.
2. Place the door assembly on the two (2) hinge pins
mounted on the body of the unit. Refer to Figure 37.
3. Open and close the door, applying pressure down, to
ensure the door assembly is properly seated on the
hinges. Refer to Figure 38.
Figure 37: Installation Door onto Unit.
Figure 36: Installation Door Handle
Hardware.
Figure 38: Closing Door.
DO NOT USE DOOR IF GLASS IS BROKEN.
32