Filter
Top Products
Installation
FIREPLACE POKER HANGERS - FREESTANDING:
A
B
B
1. If the surround panel is installed, remove it by lifting the panel straight
up then out.
2. For the right shroud, twist the handle on the air control clockwise to
remove it from the rod.
3. Pull unit forward a few inches, if possible.
4. Remove the screw, using a
5
/16” socket or wrench, that goes down
through the rebox top into a bent over tab at the top of the shroud
(see A in Figure 58).
5. To remove the shrouds, loosen the two (2) torx T-20 screws that hold
the shroud to the unit (See B in Figure 58). Pull the shroud forward
past the T-20 screws (approximately ” [2cm]), then out to the
side.
6. To install the shroud, follow steps 1 through 5 in reverse order. Ensure
the shrouds are hooked behind both screws on either side.
Figure 59: Removal of right
Shroud.
46
REMOVAL OF THE SHROUDS - INSERT:
When the replace poker is not in use it can be
hung at the back of the unit on either side.
Figure 58: Fireplace poker hanging.