Filter
Top Products
The Insert comes with the fan assembled
installed in the left shroud.
1) Disconnect all electrical connections for the
fan kit.
2) Remove the four (4) ” hex head screws that
hold the fan mounting plate to the shroud. If
doing a fan only replacement, remove the
four (4) T-20 screws holding the fan to the
fan mounting plate.
3) Remove the fan control knob and nut from
the front of the shroud and pull the controls
out the back.
4) Install the fan kit into the new shroud by
following reversing steps 1 to 3. Refer to
FAN WIRING DIAGRAM to ensure the fan is
reconnected properly.
FAN REMOVAL - INSERT:
Fan Temperature
Sensor
Mounting Plate
Fan
Left Shroud
Figure 57: Insert Unit with Fan.
Installation
Refer to FAN WIRING DIAGRAM before installing your optional fan
kit.
1. Remove the fan assembly from the box and inspect for
any damage to the assembly. If damage is noticed call
your dealer, distributor or courier company and have
components replaced before installing kit.
2. Remove the knock out at the bottom of the back panel of
the appliance by using a at head screwdriver as a lever,
hook the tip of the screwdriver under the panel beside the
tabs and push the panel out.
3. Install two (2) T-20 screws into the top two (2) holes. Place
the blower assembly over these two (2) screws.
4. Ensure the temperature sensor will touch the unit when
mounted. If it does not touch, adjust the sensor so it does.
Tighten the two (2) top screws and install the two (2)
bottom screws and tighten.
5. Plug the fan assembly in and check for proper operation.
OPTIONAL FAN INSTALLATION - FREESTANDING:
Figure 56: Back View of Freestanding Unit
with Fan Kit.
45