Filter
Top Products
NGA 2000 CLD
Instruction Manual
HAS60E-IM-HW
June 2007
3 - 12 Operation Emerson Process Management GmbH & Co.OHG
c. Relay Outputs Setup
There are three relays on the SIO board. The contact
logic can be set with a jumper on the SIO board to select
NO (normally open) or NC (normally closed). Full details
of the SIO board are contained in its own manual.
In the System SIO Module menu (Figure 3-11) select
"Relay outputs setup..."
Figure 3-20: Relay Outputs Setup Menu
Output number:
Corresponds to the relay number 1-3.
Invert signal:
"Disabled" signal is normal, "Enabled" signal is inverted.
Choose source module...
Figure 3-21: Choose Source Module Menu
Choose desired source module for the relay output num-
ber (1-3) being configured.
The list of modules will depend on the installed modules.
Choose signal...
Figure 3-22: Choose Signal Menu
Choose desired signal for the relay output number (1-3)
being configured.
The list of signals will depend on the chosen module. If
available, press the >>> (F5) softkey for additional sig-
nals.
The three lines displayed at the bottom of the "Relay
Outputs Setup" menu show the current status of the se-
lected relay output.
Signal comes from: The module chosenfrom the
"Choose Source Module" menu.
Signal name: The signal chosen from the "Choose Sig-
nal" menu.
Actual status: The current status of the signal; Off or
On.
Line#1
Measure
0.000 ppm
Back...
-- Relay Outputs Setup --
Output number:
Invert signal:
Choose source module...
Choose signal...
Signal comes from:
Signal name:
Actual status:
1
Disabled
????
????
Off
Line#1
Measure >>>
0.000 ppm
<<< Back...
-- Choose Source Module --
Control Module: 0.0
1000723 Line#1: 1.0
Line#1
Measure >>>
0.000 ppm
<<< Back...
-- Choose Signal --
1
Function control
Maintenance request
Failure
Cal. In progress
Zero in progress
Span in progress
Zero failed
Span failed
Pressure limits...