Filter
Top Products
1. INSTALLATION
1.1. FEATURES
DROLET ECO-65 FREESTANDING PELLET STOVE
Width: 24”
Height: 41”
Depth: 30”
Weight: 375 lbs.
Flue size: 4”
Hopper Capacity: Up to 125 lbs. (This can vary depending
on pellet size, length, and diameter)
EPA status: < 4.5 g/h.
Burn rate: 1.3 lbs to 7.9 lbs. per hour
BTU range: 10,500 to 65,000
Electrical consumption:
o 5 Amps lighting cycle
o 2.5 Amps. continuous duty
Control board fuses: Main: 7.5A-250V fastblow
o Convection blower: 5A-250V fastblow
o Combustion blower: 3A-250V fastblow
o Exhaust blower: 3A-250V fastblow
o Auger 1: 3A-250V fastblow
o Auger 2: 3A-250V fastblow
o Ignitor : 5A-250V fastblow
Electrical requirement: 120VAC 15A
Approved installations: mobile home, conventional
1.2. PREPARATION
Factory packaging must be removed, and some minor assembly
work is required prior to installation for handle and door adjustment.
Also, the stove must be leveled using threaded legs.
1.3. CLEARANCES
The Drolet ECO-65 has been tested and listed for installation in
residential and mobile home. (refer to figure 1 & 2)
FLOOR PROTECTION: minimum of 6” in the front and 6” on each
side of the door opening. The stove must be placed on a
continuous (grouted joints) noncombustible material such as
ceramic tile, cement board, brick, 3/8” millboard or equivalent, or
other approved or listed material suited for floor protection.
NOTE: ceramic tile, or any tile, requires a continuous sheet
beneath to prevent the possibility of embers falling through to the
combustible floor if cracks or separation should occur in the
finished surface, this would include floor protection for Built-in
raised hearths. Check local codes for approved alternatives.
Clearances are measured from the sides, back or face (door
opening) (refer to fig. 3). For ceiling clearance refer to figure 4.
Clearances may only be reduced by means approved by the
regulatory authority.
FIGURE 3
Floor protection
FIGURE 2
Corner installation
FIGURE 1
Back wall installation