Filter
Top Products
4. The control board is not sending power to the igniter.
Check the voltage going to the igniter during ignition. It should be a
full current. If the voltage is lower than full current, check the wiring.
If the wiring is functional and properly connected, the board is
defective. You will need a technician to perform this test.
5. The pump is not connected properly or isn‟t working properly
Verify that the plug is connected properly and if the pump is running
during the lightning cycle. If the pump isn‟t working make sure all
connections are good.
STOVE FEEDS PELLETS, BUT WILL NOT IGNITE AND APPEARS ON THE CONTROL BOARD
Possible Cause:
Possible Remedy:
1. The igniter fuse on the control board has blown.
The igniter or the pump is defective or the wiring harness shorted.
Remove the control board cover and check if the F1 fuse appears to
have blown. Replace it with a 5 Amp 250V fuse. Plug the stove
back on and try to start the unit.
STOVE FEEDS PELLETS, BUT WILL NOT IGNITE AND APPEARS ON THE CONTROL BOARD
Possible Causes:
Possible Remedies:
1. The auger jammed, the auger motor is defective or the
wiring harness shorted.
Remove the control board cover and check if the F2 fuse appears to
have blown. Replace it with a 3 Amp 250V fuse. Plug the stove
back and try to run the unit.
2. The auger fuse has blown.
Start by emptying the hopper. Then, remove the auger motor by
removing the screws holding the motor to the auger shaft Once the
motor is out, remove the four screws on the steel plate holding the
auger shaft to the auger housing. Then, rotate the bottom end of the
auger shaft down towards you until you can pull the shaft down out
of the stove. After you have removed the shaft, inspect it for bent
flights, burrs, or broken welds. Remove any foreign material that
might have caused the jam. Also, check the auger housing for signs
of damage such as burrs, rough spots, or grooves cut into the metal
that could have caused a jam. Clean the auger housing thoroughly
to remove all pellet dust. Repeat the process whit the burn pot auger
motor.
STOVE STOPS FEEDING PELLETS AND APPEARS ON THE CONTROL BOARD
Possible Cause:
Possible Remedy:
1. An overheat zone was detected on the auger housing
The L-250 automatic high temperature switch is located on the top of
the auger housing. It sends a signal to the control board if the auger
housing overheats. Wait until the stove cools down AND THEN
INSPECT YOUR UNIT. Improper installation, poor maintenance, or a
defective or missing component may be causing the stove to
overheat. Reset the stove and restart it. Call a technician if you get
this code again.
*** After 3 attempts, reset is no longer possible, call SBI technical support.