Filter
Top Products
19
7. Either pinch the clasp to release or cut each of the four
(4) mounting studs (one in each corner of the Log Driver
Board) that attach the circuit board to the chassis of the
rebox.
!
NOTE: If mounting studs are cut, ensure they are
replaced by those supplied with replacement board.
8. Clear both ends of mounting studs if cut.
9. Install replacement mounting studs (if necessary) by
pushing them through the sheet metal from the outside of
the rebox.
10. Properly orientate replacement Log Driver Board and
push onto mounting studs until all four (4) snap closed.
10. Remove one wire terminal from original Log Driver Board
and install onto replacement Log Driver Board, matching
its original position.
11. Continue with remaining wire connections, moving one
wire at a time, matching its original position.
WARNING: Improper re-connection of wiring may result
in electric shock, re, or injury to persons. Ensure that
connections to/from circuit board match those of the
respective wiring diagram for the particular model and
MOD level being serviced (pages 7-10).
12. Once all connections are made, follow steps 1 and 2 in
reverse order to reassemble the rebox.
Figure 21
Log Driver
Board