Desa VMH26NR8 Indoor Fireplace User Manual


 
www.desatech.com
113110-01H 25
Figure 39 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Hand-Held Remote Operation
O
F
F
P
I
L
O
T
L
O
I
H
REMOTE
OFF
ON
O
N
Flame
Adjustment Knob
Control Knob
Selector Switch in REMOTE Position
(Optional Hand-Held Remote Control)
Figure 40 - On/Off Hand-Held Remote
Control Unit

-
Lighting
Instructions
After lighting, let pilot ame burn for about
one minute. Turn control knob to ON position.
Adjust ame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 39).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave selector switch in
REMOTE or ON position when pilot is not lit.
This will drain the battery.
OPERATION
Continued
Figure 41 - Thermostat Hand-Held
Remote Control Unit

The hand-held remote can be operated using
either manual mode (MANU) or thermostatic
mode (AUTO) (see Figure 41). To select Fahr-
enheit/Centigrade mode display, carefully
press ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1.
Press POWER and LOCK buttons together
to turn on hand-held remote control.
2. Press MANU button to turn on replace.
3. Press POWER and LOCK buttons to-
gether to turn off replace.

1.
Press POWER and LOCK buttons together
to turn on hand-held remote control.
2. Press AUTO button to select this mode.
3. Set desired room temperature by pressing
TEMP + or - buttons.
4. Press POWER and LOCK buttons to-
gether to turn off replace
Note: Do not leave hand-held remote in the
AUTO mode close to fireplace. The radi-
ant heat coming from replace will turn off
replace. Ideally, place hand-held remote in
center of room facing towards replace.
Note: Do not hold hand-held remote for a long
time. Body temperature will affect its operation
in AUTO mode.
Control
Button
Indicator
Light
LOCK
MANU AUTO
ºC/ºF
TEMP
POWER
ROOM
TEMP
SET
TEMP
AUTO
Turns
Hand-Held
Remote On
or Off and
Allows You
to Choose
the Manual
Setting
Selects
AUTO
Mode
°C/°F
Mode
Button
Locks
System to
Prevent
Accidental
Ignition
Turns
Burners
On or
Off
Increases
or Decreases
Room
Temperature
in AUTO Mode
Digital
Display
Shows
Temperature
and Settings

Hold control button on hand-held remote until
burner turns on. Hold control button again until
burner turns off (see Figure 40).
press both buttons on hand-held re-
mote control until light stops ashing. Hand-held
remote control is now locked. If re is on it will be
turned off automatically. In locked state, light will
not light up when any button is pressed.
press both buttons together on
hand-held remote control until light stops ash-
ing. Hand-held remote is now unlocked.