Filter
Top Products
www.desatech.com
117437-01D20
O
F
F
P
I
L
O
T
O
N
OPERATING FIREPLACE
MANUAL IGNITION SySTEM
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a re or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance is equipped with an igni-
tion device which automatically lights
the pilot. Do not light pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the oor because some
gas is heavier than air and will settle
on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the re department
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn
by hand, don't try to repair it, call a
qualied service technician. Force or
attempted repair may result in a re or
explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualied service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
LIGHTING
INSTRUCTIONS
1. STOP! Read the safety information
above.
2. Open lower louver panel.
4. Push in gas control knob slightly and turn
clockwise to OFF (see Figure 33).
Figure 33 - Control Valve Millivolt
“B” in the safety information above. If you
don’t smell gas go to the next step.
6. The pilot is located by the main burner and
should not require accessing for lighting.
7. Turn gas control knob counterclockwise
to PILOT.
8. Push in gas control knob all the way and
hold. Immediately light the pilot by repeat-
appears. Continue to hold for about one
(1) minute after the pilot is lit. Release
gas control knob and it will pop up. Pilot
steps 5 through 8.
• If gas control knob does not pop up when
service technician or gas supplier.
turn gas control knob to OFF and call your
service technician or gas supplier.
10. Turn gas control knob counterclockwise
to ON.
11. To leave pilot lit and shut off burners only:
turn control knob clockwise to the
PILOT position. Set wall switch or remote
selector switch to OFF position to prevent
draining battery.
12. Close lower louver panel.
Gas Control Knob
Regulator Cap
TO TURN OFF GAS
TO APPLIANCE
1. Open lower louver panel.
2. Set the wall switch to “OFF” position or the
HRC selector switch (when equipped) to
prevent draining the battery.
3. Turn off all electric power to the appliance
if service is to be performed.
4. Push in gas control knob slightly and turn
clockwise to OFF.
5. Close lower louver panel.
6. Close equipment shutoff valve (see Figure