Filter
Top Products
www.desatech.com
117437-01D 13
4. Connect one wire from receiver to male
connector on high limit harness and one
page 12).
5. Locate two plastic mounting clips provided
with kit.
mounting bracket as shown in Figure 16.
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to a 9-volt alkaline
battery (not included). Place battery into
battery housing (see Figure 17).
3. Replace battery cover onto remote con-
trol unit.
INSTALLING OPTIONAL CONTROLS
Continued
9-Volt
Battery
Battery
Housing
Battery
Cover
Terminal
Wires
Remote
Control
Towards Front
REMOTE ON OFF
Figure 16 - Mounting Remote Receiver to
Bracket
Figure 17 - Installing Battery in Hand-
Held Control Unit (HRC100 Series)
Figure 18 - Installing WRC Remote Receiver
Figure 19 - Installing Battery into Back of
Handset
Fireplace
Receptacle
Remote
Control
Receiver
Extension Cord
Ignition
Module
Plug
Pull to
Remove
Insulation
Tab
Battery Cover
12 Volt Battery
Back of Handset
Plastic Mounting
Clips
Remote Receiver
INSTALLING OPTIONAL WIRELESS
REMOTE CONTROL - MODEL WRC
(Electronic Ignition)
Installing and Activating the Remote
Receiver
1. Open bottom louver and locate plug re-
ceptacle. Plug receptacle is located either
on right or left side of cabinet.
2. The WRC model receiver does not require
a battery. Receiver can be installed by
unit into extension cord. Finally plug igni-
tion module plug into receiver unit (see
Figure 18).
3. Activate remote handset battery by re-
moving insulating tab on back of handset
(see Figure 19). Battery is included pre-
installed.
4. Once battery is activated unit is ready to
use.
5. Replace bottom louver panel.