Filter
Top Products
Installation Step 4
Position the Opener
Follow instructions which apply to your door
type as Illustrated.
i
A 2x4 laid flat is convenient for setting an Ideal
door-toT-rail distance.
• Raise the opener onto a stepladder.
You will need help at this point ff the ladder is
not tall enough.
• Open the door all the way and place a 2x4 laid flat
on the top section beneath the T-rail.
ff the top panel hits the trolley when you raise
the door, pull down on the trolley release arm to
disconnect the Inner and outer sections. The
trolley can remain disconnected until Step 12 Is
completed.
Door
T-ra_
2x4
I
ReleaseAnn
T_ley
• With the door fully open and parallel tothe floor,
measure the distance from the floor to the top of
the door.
• Using a stepladder as a support, raise the opener
to the same distance as the door from the floor (it
will be at a slight angle as shown).
• The top of the door should be level with the top of
the opener. Do not position the opener more than
2' above this point.
Header
16