Filter
Top Products
UGE014/0999 Water/Spray Tanks
INTRODUCTION 1-3
We design equipment with the user’s safety in mind. You can
avoid the potential hazards identified on this machine by
following the procedures outlined below and elsewhere in
the User Guide.
ATTENTION:
R
EAD THIS SO NO
ONE GETS HURT
!
WARNING: Voltage hazard
This equipment is powered by three-phase
alternating current, as specified on the machine
serial tag and data plate.
A properly sized conductive ground wire from
the incoming power supply must be connected
to the chassis ground terminal inside the elec-
trical enclosure. Improper grounding can result
in severe personal injury and erratic machine
operation.
Always disconnect and lock out the incoming
main power source before opening the electri-
cal enclosure or performing non-standard oper-
ating procedures, such as routine maintenance.
Only qualified personnel should perform trou-
bleshooting procedures that require access to
the electrical enclosure while power is on.
WARNING: Improper installation,
operation or servicing may result in
equipment damage or personal injury.
This equipment should be installed, adjusted,
and serviced by qualified technical personnel
who are familiar with the construction, opera-
tion and potential hazards of this type of
machine.
All wiring, disconnects and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the the machine serial tag and
data plate.
You should keep the area around the tank
clean and free from pooling water. We recom-
mend installing a grate or drain system beneath
this equipment to prevent water from pooling
around the tank.