Filter
Top Products
UNPACKING
THE
BOXES
Water/Spray Tanks UGE014/0999
3-2 INSTALLATION
Installation Hardware Needed:
❒ wire strain relief (for recirculation package only)
❒ one plumb bob or laser bore sight
❒ one hex key wrench
❒ one flathead screwdriver
❒ flexible hose with 1.5 inch NPT coupling
CAUTION: Exercise caution when moving the
WT/ST tank. The tank may be lifted with a fork-
lift or hoist and straps that have been positioned
at the tank’s center of gravity.
!
The WT/ST tank comes fully assembled in a single crate.
Carefully uncrate the tank and its components.
Remove all packing material, protective paper, tape,
and plastic. Compare contents to the shipping papers to
ensure that you have all the parts.
Carefully inspect all components to make sure no
damage occurred during shipping. Check all wire terminal
connections, bolts, and any other electrical connections,
which may have come loose during shipping. Immediately
report any damage or missing components to the freight
company that delivered the tank.
Take a moment to record serial numbers and
specifications in the blanks provided on the back of the
User Guide’s title page. The information will be helpful
if you ever need service or parts. The User Guide is in
a folder inside the tank.
You are now ready to begin installation.
Complete the preparation steps on the next page.
1
2
3
4
5