Filter
Top Products
Water/Spray Tanks UGE014/0999
3-4 INSTALLATION
Position the tank downstream of the extruder.
Place the tank inline with the extruder. Set the tank’s
v-groove casters on the v-rails, if present.
Adjust the height of the tank to match the extrud-
er’s centerline height. Use a level and turn the hand wheels
to adjust height at both ends of the tank.
Adjust the horizontal (side-to-side) position of
the tank.
If you have the horizontal adjustment option,
turn the handwheel to align the unit with other compo-
nents in the extrusion line. Use a plumb bob or laser to
guide the alignment.
ALIGNING THE
TANK
1
2
3
CAUTION: To avoid personal injury or damage
to the tank, you should lift and move the tank
with a forklift or hoist and straps positioned at the
tank’s center of gravity.
!
WARNING: Improper installation could
result in equipment damage and severe
personal injury from electrical shock .
Electrical connections should be made only by
qualified personnel. This machine requires a
well-grounded circuit and three-phase alternat-
ing current as specified on the data plate. If the
correct power supply is not available, you must
install a transformer between the building sup-
ply and the machine. A properly sized conduc-
tive ground wire from the power supply must be
connected to the ground terminal on the tank.