Filter
Top Products
Water/Spray Tanks UGE014/0999
6-2 TROUBLESHOOTING
You can avoid most problems by following the recommended
installation, operation and maintenance procedures outlined in
this User Guide. If you do have a problem, this section will
help you determine what caused it and tell you how to fix it.
Before you begin troubleshooting:
❏ Find the wiring, plumbing and assembly
diagrams that were shipped with your equipment.
These diagrams are the best reference for correcting a prob-
lem. The diagrams also will note any custom features, such as
special wiring, control or plumbing options, not covered in
this User Guide.
❏ Verify that you have all instructional materials
related to the WT/ST tank.
Additional details about
troubleshooting and repairing specific components of the tank,
including pumps and heat exchanger can be found in the man-
ufacturers manuals included in this instruction packet.
❏ Verify that you have manuals for equipment
located upstream of the tank on the extrusion line.
Solving problems related to extrudate quality may require
troubleshooting malfunctions or incorrect operating proce-
dures on other pieces of equipment in the extrusion line.
B
EFORE
BEGINNING
A F
EW WORDS
OF
CAUTION
WARNING: This machines should be
adjusted and serviced only by qualified
technical personnel who are familiar with
construction and operation of this type of
equipment.
!
DANGER: Voltage hazard.
Troubleshooting the electrical system of
this equipment requires use of precision
electronic measuring equipment, as well
as access to the electrical enclosure
while power is on. Exposure to potentially
fatal voltage levels is unavoidable. These
troubleshooting procedures should be
performed only by qualified electrical
technicians who know how to use this
precision electronic equipment and who
understand the hazards involved.