Filter
Top Products
SECTION IV
INSTALLATION OF MODEL 384 (WS) WITH
OPTIONAL WOODEN SURROUND (KIT#PAKDM384)
NOTE: See page 20 for clearances.
(1) When choosing the right location for your heater and wooden surround keep the following
in mind:
NOTE: Due to high temperatures, this heater should be located out of traffic
areas and away from furniture and draperies.
CAUTION: THE INSTALLATION MUST CONFORM TO LOCAL CODES. IN THE
ABSENCE OF LOCAL CODES, INSTALLATION MUST CONFORM WITH
THE NATIONAL GAS CODES.
NOTE: See Section II for gas hookup and pressure check.
NOTE: See “Producing Adequate Ventilation” page 31.
WARNING: CHILDREN AND ADULTS SHOULD BE ALERTED TO THE HAZARDS OF
HIGH SURFACE TEMPERATURES AND SHOULD STAY AWAY TO AVOID BURNS OR
CLOTHING IGNITION. YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED
WHEN THEY ARE IN THE SAME ROOM WITH THE APPLIANCE.
WARNING: DO NOT PLACE CLOTHING OR OTHER FLAMMABLE MATERIAL ON OR
NEAR THE APPLIANCE.
(2) Position screen before leaving heater unattended.
(3) Instructions for assembly of Wooden Surround (Mantel):
TOOLS NEEDED: Medium Phillips screwdriver, tape measure, power drill, and 5/16" socket.
STEP 1: Lay out all components.
STEP 2: Assemble end panels A & B to top front rail C.
STEP 3: Stand end panels and top front rail onto hearth.
NOTE: (Position back of end panels with back of hearth centering assembly
from each end). Install front screws first, then pull back towards the inside to
square the mantel. Install screws through back holes.
STEP 4: The owner must decide at this time if parts D, E, and F are to be wood or green.
Beginning with panel E stand chosen color face out on hearth flush against stop block located
inside end panel A and attach. Position the left end of top window D on top of E and attach.
Slide panel F under the right end of D and attach.
STEP 5: Place a cloth or blanket over the front portions of mantel as not to scar the wooden
part of the mantel.
The Manufacturers Trim Kit must be used for Wooden Surround Installation.
1. Set the top (long) trim panel in place on top of unit. The panel should be flat against the
outside face of the fireplace, and standing vertically (measuring approximately 12” from the
rear of the unit to the front area). Mark along the lower edge of the trim panel with a pencil to
make reference line for mounting.
2. Set the side panels in place, flat against the fireplace. Mark down the inside edge of the trim
panel to make a vertical reference line.
Page 22