Filter
Top Products
55
°F
Set Temperature
In Use
Priority
e n d l e s s h o t w a t e r s y s t e m
CAUTION: Hotter water increases the risk
of scald injury. Before changing temperature
setting, see instruction manual.
C O R P O R A T I O N
R
P
o
B
P
r
i
r
i
t
y
u
t
t
o
n
Temperature
Display
In Use
Indicator
Priority
Button
Priority
Indicator
Thermostat
Figure 44. Remote Control and the Description of Functions on All Controls.
Residential Control, p/n 239-47806-00
Commercial Control, p/n 239-47805-00
Installation of Remote Control(s) (Optional)
1. The optional remote controls are intended to be installed in a bathroom close to a shower or tub.
The controls may be wired in parallel only.
2. Mark the holes on the wall using the control mounting plate and drill two mounting holes using a
3/32” (2.4 mm) drill bit and a clearance hole for the cable using a ¼” (6.4 mm) drill bit.
3. Run the cable from the control to the water heater or another control, whichever is closer or more
convenient.
4. Remove the face plate from the remote control by inserting a screwdriver in the slot and twisting
open.
5. Connect the cable to the terminal screws of the remote control.
securing screw
1-21/32"
3-5/16"
securing screw
wiring hole
Figure 45. Outline of Remote Control's Mounting Plate.