Filter
Top Products
Setting a Permanent Temperature Hold
-51-
Temperature
digits are flashing
Figure 106
If an alternate water temperature is required for an indefinite amount of time, follow the
instructions in this section to modify the Setback water temperature for an open ended amount
of time.
Setting a New Water Temperature
Step 1: From the Home screen, press the UP (increase water temperature) or DOWN (decrease water
temperature buttons until the new desired water temperature is shown. This is shown in Figure 106.
Display of Permanent Hold Water Temperature
Step 2: A permanent hold will maintain the water heater setpoint at the new setting indefinitely. Press the
LEFT (Hold) button to establish a permanent hold. When the Setback Control is in a permanent hold, the
“Hold,” in the lower left corner of the display, will be shown continuously (not flashing). This is shown in
Figure 107.
Figure 107
Exiting a Permanent Hold
Step 3: To exit a Permanent Hold, press the RIGHT (Schedule) button, as shown in Figure 108.
Figure 108
"Hold" is continuously shown
(
not flashin
g)
for a Permanent Hold.