Filter
Top Products
Remote Mounting the Setback Control
-13-
Install Wire (B) – Backplate
Step 10: Using wire (B), insert one end into the middle terminal location on the backplate (located on the
Setback Control Junction Box Assembly). This is shown in Figure 16. Be sure that the wire already
located in this location is not dislodged.
Fasten Wire (A) into its Designated Location – Backplate
Step 9: Tighten the slotted screw in the top terminal location on the backplate (located on the Setback
Control Junction Box Assembly). This is shown in Figure 15.
Figure 15
Figure 16
Wires Already
Installed
Wire (A) Wire (B)
Backplate
Slotted head
screwdriver
Backplate
Setback Control
Junction Box Assembly
Wire (A)