Filter
Top Products
Remote Mounting the Setback Control
-11-
Measure Wire for Remote Mounting
Step 5: Measure and cut (3) pieces of 18 AWG wire to a sufficient length to reach from the backplate on
the Setback Control Junction Box Assembly to the Setback Control Protective Plate. This is shown in
Figure 11.
Label the Wires for Remote Mounting
Step 6: Label the (3) cut wires (A), (B), and (C) respectively. Label both ends of the wires. This is shown
in Figure 12. Masking tape can be used to label the wires.
Figure 12
Label Each
Wire
18 AWG
Wire
Figure 11