Filter
Top Products
Remote Mounting the Setback Control
-17-
Install Wire (B) – Protective Plate
Step 17: Using wire (B), insert one end into the middle terminal location on the Protective Plate. This is
shown in Figure 22.
Figure 22
Fasten Wire (B) into its Designated Location – Protective Plate
Step 18: Tighten the slotted screw in the middle terminal location on the Protective Plate. This is shown in
Figure 23.
Figure 23
Protective
Plate
Slotted head
screwdriver
Wire (A)
Wire (B)
Wire (A)
Wire (B)
Protective
Plate