Filter
Top Products
CC880/LP880, SC8016 | Operators Guide | 28.0 PET Pager Reporting EN | 19
Bosch Security Systems | 6/04 | 920036O.OG.162
28.0 PET Pager Reporting
The system can be configured by your security
company to report to a pocket pager when an
alarm and/or any system event occurs. When
using either of these two reporting formats, easy to
understand text messages are received so that the
appropriate action can be taken.
Table 17 lists all the events that can be reported in
PET pager formats.
Table 17: PET Pager Messages
Event At Control Panel PET Message
AC Fail AC Fail
AC Restore AC Restore
Area Has Been Armed Close Area #, User #
Area Has Been Disarmed Open Area #, User #
Burglary Zone Has Triggered Alarm Zone #
Burglary Zone Has Restored Restore Zone #
Burglary Zone Triggered, Area # Alarm Zone #, Area #
Burglary Zone Restored, Area # Restore Zone #, Area #
Access Denied – Codepad Tamper Codepad Tamper
Data Programming Change Data Change
System Is Armed Close User #
System Is Disarmed Open User #
Codepad Duress Duress, Open User #
Low Battery Low Battery
Low Battery Restore Battery Restore
Codepad Panic Alarm Panic
Codepad Fire Alarm (V1.37+) Fire
Codepad Medical Alarm (V1.37+) Medical
Test Report Test
Zone Automatically Isolated When
Armed
Bypass Zone #
Disarming When Zone Has Been
Isolated
Bypass Restore Zone #
Zone Unsealed At End Of Exit Time Trouble Zone #
Zone Has Restored After Exit Time Trouble Restore #
24 Hour Zone Triggered 24 Hour Alarm #
24 Hour Zone Restored 24 Hour Restore #
24 Hour Fire Zone Triggered Fire Zone #
24 Hour Fire Zone Restored Fire Restore #
The # symbol represents the zone or area number
in the transmission.
The following example shows how a single
transmission is received on the PET pager. A
similar message to the one below is seen when the
control panel is armed by User 1.
Table 18: Example of a Single Transmission
1111 CLOSE USER 01
Subscriber ID Number System Armed User #1
The Subscriber ID number is a unique 4 digit
number identifying which alarm system made the
call. Only your security company can program the
Subscriber ID number (Factory Default = 0000).