CC880/LP880, SC8016 | Operators Guide | 25.0 Domestic Dialling EN | 16
Bosch Security Systems | 6/04 | 920036O.OG.162
25.0 Domestic Dialling
Use domestic dialling to call your mobile phone or a
relative/friend in the event your control panel
activated an alarm. Up to three different telephone
numbers can be programmed for the control panel to
call when an alarm occurs. Only your installer can
program the system to report in the domestic format.
However, the master code holder can change the
telephone numbers at any time.
25.1 Acknowledging Domestic Calls
When an alarm condition occurs, the system calls the
first telephone number programmed. When you
answer an incoming call, you hear the system
emitting a siren tone followed by a pause and repeat
continually for 2 min. (for example, siren tone,
pause, siren tone, and pause).
If you do not acknowledge the call from the control
panel during a pause between siren tones, the control
panel hangs up after 2 min. and calls the next
telephone number.
Pressing the [*] button for 1 sec. to 3 sec. during the
pause acknowledges the call and no further calls are
made for that event. If the call was successfully
acknowledged, a tone of decreasing pitch is heard.
Table 14: Domestic Dialling Telephone Digits
Digit Required Number To Program
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
* *1
# *2
4 sec. pause *3
Break *4
25.2 Programming Domestic Telephone
Numbers
If your system is set up for domestic dialling, this
function allows any master code holder to program
telephone numbers the control panel calls in an
alarm.
How to Program Telephone Numbers
1. Enter your four character master code, followed
by [2] and the [#] button (for example,
[2 5 8 0 2 #]).
Three beeps are heard and the STAY and
AWAY indicators flash.
If there are telephone numbers already
programmed, they are displayed one digit at a
time by the codepad indicators.
If there are no telephone numbers programmed,
two more beeps are heard after entering this
mode. These two beeps are normally heard after
the last digit of the last telephone number is
displayed.
2. Enter all digits for the first telephone number (for
example, [9 6 7 2 1 7 1 7]).
As each digit is entered, the corresponding
codepad indicators display.
3. If there is more than one telephone number to
be programmed, press [*]. This inserts a break
between the first telephone number and the
second telephone number. If there is only one
telephone number to be programmed, press the
[#] button to exit this function.
4. Enter all the digits of the second telephone
number (for example, [9 6 7 2 1 0 5 5]).
As each digit is entered, the corresponding
codepad indicators display.
5. After the last digit of the second telephone
number is programmed, press the [#] button to
exit this function unless a third telephone
number is required. If there is a third telephone
number to be programmed, press the [*] button
to insert a break between the second telephone
number and the third telephone number.
25.3 Disable Domestic Dialling
To cancel domestic dialling (for example, you are
moving and do not want the system to continue
calling your mobile phone), enter the following
sequence.
1. Enter your four character master code, followed
by [2] and the [#] button (for example,
[2 5 8 0 2 #]).
Two beeps are heard and the STAY and AWAY
indicators flash.
2. Press the [*] button followed by the [#] button
(for example, [* #]).
The STAY and AWAY indicators are disabled.