Filter
Top Products
Post-treatment Scotchgard Protector* (optional)
Machine care continued
7. To clean attachments that may have been used,
remove from hose and rinse in clean, running water.
Dry and replace attachment in the tool caddy. Clean
the flex hose by suctioning clean water from the tap.
Before replacing, lift end of flex hose and stretch out
to ensure all water is cleared from flex hose. Refer to
page 15, illustrations 9 & 10.
8. After carpet is dry, vacuum again to remove
hair and fuzz.
Some models are equipped with a Scotchgard
protector post-treatment applicator and cartridge.
Using this, along with one of the BISSELL deep
cleaning formulas containing Scotchgard, to help
retain the carpet cleanliness achieved with the
ProHeat 2X machine. For best results, the post
cleaning treatment should be applied while the carpet
is still damp. It is recommended that the Scotchgard
protector be applied every 12 months to all clean
carpeted areas, and after every deep cleaning for high
traffic areas such as entryways and stairs.
1. Immediately after cleaning and rinsing your
carpets, empty the 2-in-1 water tank and refill the
heavy duty bladder with clean hand hot tap water.
2. Set Ready Tools dial to the hose/attachment setting.
3. Purge the hose to eliminate cleaning formula
from the tube by spraying clean water through
the flex hose (without attachments) into a sink
for 15-30 seconds.
4. Attach Scotchgard protector post-treatment
cartridge to the applicator tool, following the
instructions on the cartridge. Attach the combined
tool/cartridge to the flex hose. The water from the
2-in-1 water tank will automatically mix with the
concentrated Scotchgard protector post-treatment
formula contained in the cartridge.
5. Turn the Custom Clean dial to the rinse/
protect setting.
6. Before applying Scotchgard protector to
a large area, test in a small, hidden area
for colourfastness. Examine area when
dry. If colour is affected, do not use. For
use on upholstery, look for manufacturer’s
cleanability code tag. Use only on fabrics
coded “W” or “WS”. If coded “S” or “X”, do
not use. Not recommended for use on velvet,
silk vinyl, leather, or 100% cotton upholstery.
Maintenance and care
Tip:
If clogged, soak
applicator tool
in hand hot tap
water before
using.
3.
4.
13
w w w . b i s s e l l . c o m