36 Optional Equipment
Travis Industries Newport 290902
Optional Log (Part # 98900126)
! Make sure the heater has
fully cooled before
installation.
1 Open the door (see the
instructions included with
the owner’s manual.
2 Attach the two log shelf
legs to the cross brace with
the four included nuts.
Make sure to use the
correct leg for each side.
Right Log Shelf Leg
Left Log Shelf Leg
Log Shelf Cross Brace
3/8" Nutdriver
Nuts
3 Install the log shelf assembly and log following the directions below.
Center the log on the log shelf and
push it back so it rests against
these two tabs.
Place the log shelf assembly so the
back edge contacts the cast firebrick
in the rear of the firebox. Note how
the taper on the assembly matches
the taper on the cast firebrick.
a
b
NOTE:
On inserts, the ash box must be
installed before placing the log shelf
assembly.
When in place, the log should appear as
shown in the photograph to the right.