Filter
Top Products
34 Optional Equipment
Travis Industries Newport 290902
Thermostat (Part # 99300650)
! Do not connect 120 VAC
to the thermostat circuit of
this heater (do not use a
household thermostat
used for a wall-board or
other electical heater).
1 Attach the thermostat wire to
the circuit board (see the
illustration to the right). Route
the wire through the back of the
heater (away from any hot or
moving components).
2 Determine a location for the
thermostat that is within range of
the 20' length of thermostat
wire. It should be centralized in
the room and away from the
heater. The wire may be routed
externally on the wall or behind
the wall (preferred).
3 Follow the directions to the right
to attach the thermostat and
thermostat wires.
Attach the quick-connects
to the two posts near the
molex connector on the
circuit board (orientation
does not mater).
50 60 70 80 90
50 60 70 80 90
Robertshaw
Run the thermostat wires
through the wall (cut off excess
wire, leaving 6” of slack).
Pull the cover off the thermostat
Expose 1/2” of wire and
attach to these two posts.
Standard
Screwdriver
Attach the thermostat to
the wall through these
two holes.