Filter
Top Products
18 Operation
Travis Industries Newport 290902
Manual Mode
Manual mode requires the user to turn the
heater on and off manually.
To Start
Press the "Manual Start" button. That's it. The
stove automatically goes to a medium burn rate
and high fan while the igniter starts the fire
burning within 10 minutes. During this period
the lowest “HEAT OUTPUT” light will flash. If
the stove does not start in 30 minutes, the
stove turns off.
Once up to temperature, the stove will then
run at the heat output setting selected on the
control panel (see “To Adjust the Heat” below).
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
To Shut Down
Move the mode switch to "OFF". The exhaust
blower will still run until the heater cools down.
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
To Adjust the Heat
Press the "Heat” buttons to adjust the heat
output.
NOTE: During start-up you may adjust the heat
setting. This heat setting will take affect once
the start-up sequence is complete.
HIGH
DISCONNECT POWER BEFORE SERVICE
REMOTE
AUTO
MANUAL
H
E
A
T
O
U
T
P
U
T
MED
LOW
AUGER
FAULT
AUTO
OFF
MANUAL
H
E
A
T
F
A
N
UP
DOWN
UP
DOWN
MANUAL
MANUAL
START
AUGER
TRAVIS INDUSTRIES
HOUSE OF FIRE
TM
These lights
indicate the
heat output
setting.
NOTE: the
lights may
be difficult to
see from an
angle.
Press the
“up” or
“down”
button to
adjust the
heat output.