Filter
Top Products
40 Optional Equipment (for qualified installers only)
Travis Industries 93508115 4050113
4 Make sure all of the wiring is placed away from the blower impeller and the bottom of the burner. Use
lock ties, if necessary, to ensure no wires are damaged.
5 Open the control cover following the directions below. Remove the button plug and install the
rheostat.
Back of
Stove
Loosen the two screws holding the control
box in place. This allows access to the
back of the control box.
a
b
c
Remove the button plug
from the control box.
Attach the rheostat wires to the two
quick connects inside the control
box (orientation does not matter).
Control Box
e
Rheostat
1/2"
Wrench
NOTE: this tab fits into the
hole on the mounting bracket.
Attach the rheostat to
the control panel with
the included nut and
star washer.
Attach
the knob.
NOTE: make sure the
fiberglass heat shield is in
place when re-attaching the
control box.
Phillips
Screwdriver
6 Plug the blower in. Let the heater achieve operating temperature and test blower operation.
Fireback (Part # 99600220)
WARNING: Turn the gas control valve to off and make sure the appliance has fully cooled prior to
conducting service.
1 Before installing, remove the face, glass, and logs. Install the firebacks following the directions below.
Remove the screws at the
top of the firebox walls.
5/16" Nutdriver
a
c
Place the side firebacks on
the ledges at each side of
the firebox.
Fireback Clip
Side Fireback
b
Place the rear fireback (it
rests on the two ledges on
each side of the firebox).
The side firebacks keep the
rear fireback from tilting
forward.
Secure the firebacks with the
included clips and screws
(removed in step “a”).
d
Rear
Fireback