26 Operation
Travis Industries 93508115 4050113
Starting The Pilot Flame
The pilot flame is required to ignite the main burners
(it also plays a safety role). It should be left on
once lit. It will stay lit unless the gas control valve
is turned to "OFF". However, the pilot will go out if
the gas is shut off, the propane tank runs out (or
low) or if the stove malfunctions. If the pilot turns
off frequently, call your dealer for information. To
start the pilot follow the directions below:
WARNING :
When lighting or re-lighting the pilot,
the glass must be removed (see page
22).
a Remove the glass (see page 22 for details).
b Push the gas control knob in slightly and turn it to
the "OFF" position. The knob will not turn from
"ON" to "OFF" unless the knob is depressed
slightly. Wait five minutes to let any gas that
may have accumulated inside the firebox
escape. If you smell leaking gas, follow the
directions on the cover "IF YOU SMELL GAS".
c Turn the gas control knob to the "PILOT" position
and press the knob in, this will allow gas to flow to
the pilot light. Press the button on the pilot igniter
repeatedly until you see the pilot light.
WARNING:
If the pilot does not light after 15
seconds, release the knob and call
your dealer for service. Do not attempt
to light pilot until service has been
performed.
NOTE:
You may wish to remove the log set to
gain a better view of the pilot (see page
24).
d Keep the gas control knob depressed for 30
seconds once it is lit.
e Release the gas control knob. If the pilot goes
out, repeat step C. If the pilot refuses to stay lit,
call your dealer for service. With the pilot lit,
proceed to step “f”.
NOTE:
If the gas control knob is turned to
“OFF” after the pilot has been lit for
several seconds, the knob will not turn.
This safety feature prevents gas from
entering the firebox.
f Replace the glass.
g Turn the gas control knob counter-clockwise to
"ON". The pilot is now lit and the heater can be
turned on and off.
?
30 seconds
PILOT
IGNITER
a
b
5 minutes
c
d
e
f
g