Filter
Top Products
28 Operation
Travis Industries 93508115 4050113
Adjusting the Blower Speed (optional)
The blower helps transfer the heat from the heater into the room. It will not turn on until the heater is
up to temperature (approximately 10 minutes after starting). See the illustration below for instructions
on adjusting the blower speed.
ON
OFF
ON
OFF
ON
OFF
OFF
Turn the dial all
the way counter-
clockwise until it
clicks off.
HIGH
The high position is
all the way counter-
clockwise,
without
clicking off.
LOW
Turn the dial
all the way
clockwise.
Normal Operating Sounds
Gas Control Valve
As the gas control valve
is turned on and off you
will hear a dull clicking
sound. This is the valve
opening up and shutting
down.
Blower Snap Disk
This part can produce a clicking sound
as it turns the blower on and off.
The appliance may creak with
change of temperature.
THIS IS NORMAL.
Pilot Flame
The pilot flame, which
remains on, makes a
very slight "whisper"
sound.
Blower
This heater uses a blower to push heated air
into the room. You will hear the sound of air
movement that increases as the speed is
increased.
Extinction Pops
It is not unusual, especially on Propane (LP)
appliances, to experience a "pop" when the
burner is shut off.
Normal Operating Odors
This appliance has several areas that reach high temperatures. Dust or other particles on these areas may
burn and create a burnt-paper smell. This is normal during startup. You may notice the smell is more acute
if the appliance was left idle for a long period.