Filter
Top Products
Operation 25
Travis Industries 93508115 4050113
Before You Begin
Warning: Read this entire manual before you use your new stove (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property
damage, bodily injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of
the glass should be done by a licensed or qualified service person.
Location of Controls - See explanation below
Swing the control cover
down to access the gas control
valve and pilot igniter.
The Pilot Flame
can be found below
the back log.
IGNITER
Pilot Igniter
ON/OFF
Switch
The on/off switch and optional blower
control are located on the back of the
heater.
Gas
Control
Valve
Gas Control Knob
Flame Adjust Knob
An instruction card for operating
the fireplace is attached to the
inside of the fireplace here.
Replace it for easy reference.
ON
OFF
Optional
Blower
Control
On/Off Switch This control is used to turn the flame on and off.
Optional Blower Control This knob controls the speed of the internal convection blower that
pushes heated air into the room.
Gas Control Knob This knob controls gas to the stove and pilot. There are three positions: ON,
OFF, and PILOT. The indicator line is to the left of the knob.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI”). The
indicator line is above the knob.
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
? If using a remote control or thermostat, the On/Off Switch must be left "OFF". Turning the On/Off
Switch "ON" will keep the stove on always.