Filter
Top Products
USER MANUAL
ENGLISH
RS 850 33014576(4)2008-02 A
31
Maintenance
Running-in pe-
riod (after the
fi rst 50 hours)
Every 10
hours or
before use
Every
150
hours
Every
300
hours
Every
500
hours
Every
1,000
hours
Every
2,000
hours
Engine oil change (3)
Diesel engine oil fi lter replacement (3)
Fuel fi lter element replacement (3)
Nut and screw tightening and leakage check (8) (8)
Lubrication (8)
Engine coolant line check (8)
Hydraulic system oil suction fi lter replacement (8) (8)
Hydraulic system oil drain fi lter and tank breather fi lter
replacement
(8) (8)
Engine fuel fi tting and screw tightening (8)
Glow plug check (8)
Injector check, cleaning and calibration (8)
Engine air fi lter replacement (8)
Climate control system air fi lter replacement
Alternator and fan belt replacement (8)
Climate control system belt replacement (8)
Fuel tank cleaning (8)
Engine coolant change (4) (8)
Hydraulic system oil change (3) (8)
Starter carbon brush check (8)
Brake system check (8)
Turbocharger check (8)
Minor engine overhaul (5) (7) (8)
Major engine overhaul (6) (7) (8)
(3) Or every year
(4) Or every two years
(5) After 4,000 hours
(6) After 8,000 hours
(7) Contact an authorised VM Motori S.p.A. workshop.
(8) For the relevant procedure see the Service Manual, at any Nilfi sk Service Center.
HOPPER, FILTER AND SUCTION PIPE CLEANING, GASKET CHECK AND SUCTION FAN BEARING
LUBRICATION
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing cleaning procedures using compressed
air or water gun.
Preliminary operations
Empty the hopper (7, Fig. G), drive the machine to a cleaning/washing appointed area, then engage the parking brake (13, Fig.
E).
Lift and dump the hopper (7, Fig. G), according to the procedure shown in the relevant paragraphs.
Install the lid support rod (17, Fig. F), according to the instructions shown on the relevant paragraph.
Hopper cleaning (after every use)
Clean the hopper (1, Fig. F) and the defl ector (14) with pressurized water.
Carefully check the suction sealing gasket (19, Fig. F) for integrity, and replace it if necessary.
1.
2.
3.
4.
5.