Filter
Top Products
Adtron I35MB Operations Manual
Rev. 003, PN: 610200094
5
Inserting the I35MB
To install the I35MB in the hard disk drive bay:
1. Power down the computer and remove the cover.
2. Make sure that you are properly grounded.
3. Set the master/slave to desired configurations. By default, the I35MB is set to
master.
4. Select a 3.5-inch drive bay that houses either a floppy or hard disk. If the chassis
provides a front removable panel, the buzzer reset and fault LEDs can be viewed
by removing the plastic panel on the chassis.
5. Using an 80-conductor cable (40-pin connector) connect the I35MB to the IDE
primary or secondary IDE ports.
6. Connect the power supply to the I35MB.
7. Mount the I35MB into the appropriate disk drive bay, using screws to secure the
I35MB in the chassis. See Figure 6 for mounting holes, screw size and maximum
depth.
8. Put the cover on the chassis and screw it down.
9. Power on the computer.
6-32 x 3.8mm[.
150"] MAX. DEPTH
Figure 6 Mounting Holes