Filter
Top Products
Adtron I35MB Operations Manual
Rev. 003, PN: 610200094
11
3. Note the bank number, 0 or 1, with the fault LED turned solid orange. This is the
bank that requires attention.
4. Power down the computer.
5. Remove the computer cover and locate the I35MB in the disk drive bay.
6. Disconnect the power supply and 80-conductor cable from the I35MB.
7. Unscrew the chassis mounting screws and slide the I35MB out of the disk drive
bay.
8. On the side opposite the flex cables, loosen the retaining screw for the faulted
disk drive.
9. Gently unseat the drive to a disengaged distance, approximately ¼ of an inch,
causing the flex cables to bow in a loop. (Refer to Figure 10.) Carefully
disconnect the flex cable from the faulted disk drive. Detaching the drives from
the flex cable in a forceful manner will damage the flex cable.
Bank 0
Bank 0
Bank 1
Bank 1
IDE Connector
IDE Connecto
r
Flex Cable
Retaining Screws
Figure 9 Flex Cable and Retaining Screws
10. Slide the drive out of its carrier.
11. Insert a new, working disk drive of the same capacity (or greater) with rails
installed into the carrier.
Flex Cables
Figure 10 Flex Cable View
Flex cables are extremely
fragile and should be handled
with care when attaching,
reattaching and/or
disconnecting. Not doing so will
cause irreversible damage. If
during any of the actions listed,
the flex cable becomes
damaged or unusable, please
contact Adtron Technical
Support.