Filter
Top Products
Adtron I35MB Operations Manual
Rev. 003, PN: 610200094
15
Using the I35MB Rail Kit
The following steps describe the process to disassemble and reassemble hard disk
drives on the I35MB. Attention to individual instructions is necessary to ensure
functionality and avoid damage to the device. Please contact Adtron Sales if
assembling hard disk drives other than those provided by Adtron, and refer to the
section of this manual titled, Using Different Size Media. Refer to Appendix # 1 for
a list of supplies that are included with the I35MB Rail Kit Installation.
Static Sensitive - The I35MB is a static sensitive device. Take
precautions to ensure that static does not discharge into the I35MB.
1. Position rail retention screw (#1) through left rail (#2), align screw with
corresponding hard disk, bottom side mounting hole and screw gently into place
(avoid tightening screw until second retention screw is also aligned and screwed
into place). Firmly tighten both screws but do not over tighten.
2. Repeat assembly sequence from step 1, with the right rail (# 3). Align the drive
assembly retention screw (# 4) with the left rail (# 2) as illustrated and screw
gently into place. Avoid tightening the drive assembly screw until step 4.
3. Adhere chassis ground protection barrier
1
(# 5) to the rear edge of the drive.
4. Align the completed hard disk drive assembly on the I35MB guide rails and slide
into place. Attach the drive power and signal flex cable, which will require
pulling the drive slightly out to accommodate assembly. Lastly, gently tighten
the drive assembly retention screw into place, ensuring drive does not extend
beyond the I35MB footprint, then firmly tighten the screw. Refer to Changing
Media, on page 10, for detailed instructions for attaching flex cables and
connecting the hard disk drive.
3
1
2
4
5
Figure 11 I35MB Rail Kit
1
Important: Should a drive be replaced and a new drive assembled with the original I35MB Rail Kit, a new chassis ground protection
material will be required. For example, Adtron suggests Kapton tape.