Filter
Top Products
Adtron I35MB Operations Manual
Rev. 003, PN: 610200094
12
12. Before the disk drive is fully seated (approximately ¼ of an inch to the drive
being fully seated) re-attach the flex cable to the disk drive. Refer to Figure 10 for
a view of this procedure. Carefully align and slowly attach. Pay close attention to
mounting the flex cable. Ignoring this procedure and caution can lead to damage
in future operations.
13. Tighten the retaining screw for the new disk drive.
14. The I35MB may be re-inserted in the disk drive bay, as described in Inserting the
I35MB on page 5 of this document. If your computer system does not provide
front access to the I35MB when it is installed in the bay, then connect the I35MB
to the primary or secondary ports on the IDE controller and power cable external
to the computer system to do the rebuild. The front LEDs and buttons must be
available to do the rebuild.
15. After securing the I35MB, a rebuild must be performed. Go to Rebuilding a
Bank on page 13.
Resetting Mirroring Indicators
The procedure below provides steps to reset the mirror indicators on the I35MB.
These steps address mirror indicators and DO NOT address resetting mirroring data
or data equilibrium. In addition, following these steps will only ensure subsequent
writes will be mirrored. For more information on resetting mirroring operations
beyond mirror indicators, refer to the section of this manual titled, Rebuilding a
Bank, on page 13.
Static Sensitive - The I35MB is a static sensitive device. Take
precautions to ensure that static does not discharge into the I35MB.
To reset mirror operations and change both banks:
1. While power is OFF, verify both banks are unpopulated.
2. Cycle the I35MB power to the ON state (for 5 seconds or more), then the OFF
state.
3. Insert media into desired banks.
4. Cycle power ON.
5. Once powered ON, all subsequent writes will be mirrored.