Filter
Top Products
3URJUDPPLQJ ,QLWLDO3RZHUXS
8QLPRGH31&
User Programming Levels
There are two user programming levels:
• User Master Program Level 1 is used for programming panel specific data relating
to device types, zoning, messages, control panel functions, etc.
• User Maintenance Program Level 2 is used by a qualified operator to access
features such as Disable/Enable, View and Clear History, Walktest and System
Time Change.
3.3 Initial Power-up
The following sections describe the initial programming procedures for a new system.
The same procedures are used to modify programming in an existing system.
After completing the wiring of addressable devices to the SLC, apply power to the control
panel. If the addressable devices have not yet been programmed into the FACP, their
LEDs will not flash and the following trouble message will be displayed.
3.4 Programming Screens Description
Two main options are available when the Enter key is pressed: Read Status and
Programming. Each option has multiple functions or features which may be chosen. To
view all of the choices, it is necessary that the programmer scroll through a number of
additional subscreens. These selections are displayed on multiple screens to make them
more readable for the programmer. Refer to "Master Programming Level" on page 42, for
additional information on the various screens.
The title of the main option screen will always be displayed at the top of the subscreens for
the programmer’s convenience. If additional subscreens exist, an Up or Down arrow will
be displayed in the upper right corner of the screen being viewed. The programmer can
then press the keypad Up or Down arrow key to view the new subscreen. To select one of
the choices in a screen, the programmer presses the keypad numerical key corresponding
to the desired choice.
Note that subscreens may also have multiple options which require viewing more than one
screen. The same process, as detailed in the previous paragraphs, is followed to view all
option choices.
3.5 Programming and Passwords
There are two factory set programming passwords which will access the Programming
screens as indicated in the following examples. From either of the screens, access to
specific system and device features or programming may be obtained. All user
programming entries are stored in nonvolatile memory. The factory set passwords can be
changed by the user as described in "Password Change" on page 93. If an invalid
password is entered, the blinking cursor will return to the first password character
position. To exit Programming or Read Status mode at any time, press the ESC (Escape)
key repeatedly. Note that Programming mode must be exited using the ESC key in order
to store the program data entered during this mode. If the Reset key is pressed or power is
lost before exiting Programming mode, the data just entered will not be saved.
TROUBL@IN@SYSTEM
NO@DEVICES@INSTALLED
09:03A@010801
See Page
See Page